cities skylines mod to add water sources

Cost: 2500 Upkeep: 160/week Water pumping capacity: 16000m3/week Sewage pumping capacity: 32000m3/week Creates moderate.

If they get close to the yellow zone, boost the budget if it's not at 100 or add more pipes and drains if it is. Small Clarifier by Kollati Cleans out the city sewage and convets it to fresh water and garbage. Just remember to check the water info view regularly and make sure both 'Water Availability' and 'Sewage Treatment' are in the green. However, players can't control how much water a single pump or drain can handle, and so reducing the budget is an important way to make money in the early game. The best place for the water budget to be is 100 percent, since reducing any budget line to 50 percent will reduce the service to 25 percent capacity, and raising it to 150 will only get players a 125 percent boost.

If u have a river or mountain stream that is flowing slowly, raise the altidude of the spawner. Is there any way to add resources to the ground With or without mods. A spawners current depends how much flows away from it. I started my first city (got the game today) and played for a few hours then my oil plants ran out of oil. Spwaners below bodys of water act as drains. The sliders on this page let players adjust the budget to between 50 percent and 150 percent. Oh my, thaaaanks)))))))))))) Spawners above sea level or mabe just body of exsisting or up stream water create water. To see this page, players should select the 'economy' button on the bottom-right of the interface and switch to the budget tab. This means players can lower the water budget to save money without causing any harm to citizens. If you want to plant trees or place water sources anywhere on the map use my Cross The Line mod. When players first start building a city, one pump and one drain have more than enough capacity to serve every building. You can configure which tools will be available in-game via options entry.

Cities skylines mod to add water sources